|
5A Consumer Unit (Main Fuse Box) Fuse pack of 2
These are for consumer units that take cartridge fuses. 5A fuses are colour coded white and normally used in lighting circuits. More Info>>
Item # FUSC5A
|
£2.50 |
|
15A Consumer Unit (Main Fuse Box) Fuses Pack of 2
These are for consumer units that take cartridge fuses. 15A fuses are colour coded blue and normally used in boiler, immersion heater, etc. circuits. More Info>>
Item # FUSC15A
|
£3.30 |
|
20A Consumer Unit (Mains Fuse Box) Fuse Pack of 2
These are for consumer units that take cartridge fuses. 20A fuses are colour coded yellow and normally used in boiler, immersion heater, etc. circuits. More Info>>
Item # FUSC20A
|
£3.30 |
|
30A Consumer Unit (Main Fuse Box) Fuses Pack of 2
These are for consumer units that take cartridge fuses. 30A fuses are colour coded red normally used in power (socket) circuits. More Info>>
Item # FUSC30A
|
£4.00 |
|
45A Consumer Unit (Main Fuse Box) Fuses Pack of 2
These are for consumer units that take cartridge fuses. 45A fuses are colour coded green and normally used in shower and electric cooker circuits. More Info>>
Item # FUSC45A
|
£4.80 |
|
Fuse Wire Card
This is for the old type rewirable fuse holders. Each card contains 5A, 15A and 30A fuse wire - the fuse holders are often colour coded white, blue and red respectively. More Info>>
Item # FUSCCARD
|
£0.60 |
|
Switched Fused Spur
This is used for 'hard' wiring such things as lights, heaters, etc. where you do not wish to fit a plug and socket. It is in white and will take up to 13A. A 13A fuse is fitted as standard, but this can be changed to 5A or 3A if required (please put note in comments section when placing order). It requires... More Info>>
Item # SFS
|
£3.97 |
|
Twin Switched Socket in White
A basic white with square edges, twin switched socket. This requires a back box. More Info>>
Item # TWS
|
£2.00 |
|
Single (1g) White Switched Socket
A basic white with square edges, single switched socket. This requires a back box. More Info>>
Item # SIS
|
£1.50 |
|
Single (1g) 1Way Switch in White
A basic plate switch in white with square edges Used where 1 switch only operates lights (i.e. not for 2 way systems where 2wayswitch is needed) Requires back box More Info>>
Item # SWI
|
£0.65 |
|
1g 2Way Switch in White
As previous product, but for use in 2 way systems (e.g. at top and bottom of stairs) More Info>>
Item # SW2
|
£0.95 |
|
Pull cord switch - white either 1 or 2 way
Standard white pull cord switch used in bathrooms (usually i way) and over beds (usually 2 way). The switch mechanism inside the existing switch often goes, and this is a standard replacement - screw holes being in standard positions, so no new screw holes are needed. For 1 way switches, use terminals... More Info>>
Item # PSW1
|
£2.50 |
|
LED Moonlight 1g 1way Switch (Illuminated)
Easy to locate switch for the dark or at night Suitable as a soft light forchildren or the elderly in bedrooms, hall ways, landings etc. Cost less than 1p a day to run Light is on when switch is switched off Modern design using LED light Same size and shape as an ordinary light switch, so can be... More Info>>
Item # 4401LED
|
£4.50 |
|
LED Moonlight 2g 1way Switch (Illuminated)
This is the same as 4401LED except it is used in 2 way lighting circuits (i.e. where a light can be switched on by either of 2 switches, e.g. at top and bottom of stairs) Easy to locate switch for the dark or at night Suitable as a soft light forchildren or the elderly in bedrooms, hall ways, landings... More Info>>
Item # 4402LED
|
£4.95 |
|
2g 2way Switch in White
This is a basic 2g (double) switch, i.e. it contains 2 switches on 1 plate. It can also be used 1g (single) switches, by not connecting the L2 terminal. It has square edges in white and needs a back box. More Info>>
Item # SW3
|
£1.50 |
|
3g 2way Switch in White
This is a basic 3g (triple) switch, i.e. it contains 3 switches on 1 plate. It can also be used 1g (single) switches, by not connecting the L2 terminals. It has square edges in white and needs a back box. More Info>>
Item # SW4
|
£1.97 |
|
4g 2way Switch in White
This is a basic 4g switch, i.e. it contains 4 switches on 1 plate. It can also be used 1g (single) switches, by not connecting the L2 terminal. It has square edges in white and needs a back box but note this is double the size of the i, 2 or 3g switches, so needs a double size (2g) back box. More Info>>
Item # SW5
|
£3.27 |
|
6g 2way Switch in White
This is a basic 6g switch, i.e. it contains 6 switches on 1 plate. It can also be used 1g (single) switches, by not connecting the L2 terminals. It has square edges in white and needs a back box but note this is double the size of 1, 2 or 3g switches so needs a 2g back box. More Info>>
Item # SW6
|
£4.50 |
|
Time lag light switch
Columbus adjustable pnuematic time lag switch Adjustable timing range between 10 seconds and10 minutes. Can replace existing single gang wall switches, either 1 or 2 way. Compatible with 20mm deep (or deeper) single gang BS accessory plate. For fluorescent and incandescent lighting. No neutral... More Info>>
Item # ELK400A
|
£27.00 |
|
Electronic Time Delay Switch
This is a 1g 1way switch, that fits into a normal 16mm back box and will replace any ordinary light switch. The time delay is adjustable, when fitting, to anything between 5 seconds and 10 minutes (i.e. light comes on when switch is switched on, and goes off automatically after preset time). It is suitable... More Info>>
Item # MM5503
|
£15.00 |
|
3 way switched socket adaptor
With most 3 way adaptors, if you only want on one or two of the things plugged in, you have to unplug the one(s) you don't want on. This has all 3 sockets individually switched, so everything can be left plugged in, and only the ones you need switched on. It is fused at 13A, so the maximum load is 3120W... More Info>>
Item # PL09501
|
£3.30 |
|
4g Switched Socket Converter with Neon and Circuit Breaker
This plugs into a standard UK socket (either single or twin) and converts the one socket into 4. No trailing wires so it is safe and easy to install. The adaptor has one switch, which switches on all 4 sockets. It is fused at 13A but also has an integral overload protector, reset by just pressing a... More Info>>
Item # 2348BS
|
£3.00 |
|
Switched Adaptor/Socket Converter 3 Gang
This plugs into a standard UK socket (either single or twin) and converts the one socket into 3. No trailing wires so it is safe and easy to install. Each socket is indiviually switched and has its own neon indicator, which are colour coded to match the switch, so you can switch each one on and off... More Info>>
Item # 2338
|
£6.50 |
|
4g Socket Converter
This converts a single socket into 4. It is fused at 13A. More Info>>
Item # ELC001
|
£2.95 |
|
Switched Adaptor/Socket Converter 4 Gang Surge and Spike Protected
This plugs into a standard UK socket (either single or twin) and converts the one socket into 4. No trailing wires so it is safe and easy to install. Each socket is individually switched and has its own neon indicator. You can switch each one on and off individually, and you can see at a glance which... More Info>>
Item # 2348
|
£8.00 |
|
3 Socket (3g) 6m 13A Extension Reel
Resettable thermal cut-out if cable gets too hot. Maximum loading is 3000W at 240V fully extended, 1650W at 240V fully reeled. Colour may differ from that shown. More Info>>
Item # FR1360
|
£11.00 |
|
4 Way Consumer Unit (Plastic) with 100A Double Pole Main Switch
This is fitted with a 100A double pole mains switch, but individual MCBs (up to 4) must be bought seperately see individual MCBs in this section. Rated at IP40. Max. cable thicknesses - main switch incoming 50 sq. mm., outgoing of MCB 25 sq. mm. If a 63A or 80A RCD is preferred to the switch, please... More Info>>
Item # GEVC4
|
£12.50 |
|
9 Way Consumer Unit (Plastic) with 100A Incoming Main Switch
This is fitted with a 100A double pole mains switch, but individual MCBs (up to 9) must be bought seperately see individual MCBs in this section. Rated at IP40. Max. cable thicknesses - main switch incoming 50 sq. mm., outgoing of MCB 25 sq. mm. If a 63A or 80A RCD is preferred to the switch, please... More Info>>
Item # GECVC9
|
£22.50 |
|
13 Way Consumer Unit (Plastic) with 100A Incoming Switch
This is fitted with a 100A double pole mains switch, but individual MCBs (up to 13) must be bought seperately see individual MCBs in this section. Rated at IP40. Max. cable thicknesses - main switch incoming 50 sq. mm., outgoing of MCB 25 sq. mm. If a 63A or 80A RCD is preferred to the switch, please... More Info>>
Item # GECVC13
|
£26.50 |
|
6 + 4 Split Load Consumer Unit (Plastic) with 100A Incoming Switch
This is fitted with a 100A double pole mains switch, but individual MCBs (up to 10) must be bought seperately see individual MCBs in this section. Rated at IP40. Max. cable thicknesses - main switch incoming 50 sq. mm., outgoing of MCB 25 sq. mm. There is an 80A RCD included with this, which splits... More Info>>
Item # GECVC6A4
|
£37.50 |
